Table of Contents
Advertisement
NOTE:
There must be a minimum of 24 U of usable rack space when installing the MX2008
routing into a 24-U rack.
7. Lower the pallet jack before moving the chassis. This will help distribute the weight evenly and reduce
the risk of tilting or damage to the chassis.
8. Using the pallet jack, position the router in front of the rack or cabinet, centering it in front of the rack.
NOTE:
If you are installing the MX2008 router into a network cabinet, make sure that no
hardware, device, rack, or cabinet component obstructs the 24-U rack space from access
during installation.
9. Using the pallet jack, lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounting
shelf (four-post rack) or bottom opening of the rack (open-frame rack), and position it as close as
possible.
NOTE:
Due to the short lift capability of the pallet jack, we recommended that you install
the router on the bottom of the rack.
10. Remove the shipping brackets that are attached to the pallet jack attachment and chassis, and set them
aside.
11. Grasp the handles on the shipping covers and carefully slide the router into the rack (see and
Figure 93 on page 264
continue sliding the router onto the mounting shelf so that the bottom of the chassis and the mounting
shelf overlap by approximately 2 inches.
and
Figure 94 on page
264). If you are installing the router into a four-post rack,
263
Advertisement
Table of Contents
