Table of Contents
Advertisement
RJ-45 Connector Pinouts for MX Series CB-RE or RCB Auxillary and Console Ports | 215
RJ-45 Connector Pinouts for an MX Series CB-RE or RCB Management Port | 216
Replacing an MX2008 RCB | 409
MX2008 Host Subsystem Description | 123
Supported Routing Engines by Router | 138
Routing Engine Specifications | 131
MX2008 RCB LEDs
The Routing and Control Board (RCB) is an integrated board and a single FRU that provides Routing Engine
and Control Board functionality.
Each Routing Engine part on the RCB has three LEDs that indicate its status. The LEDs, labeled ONLINE,
MASTER, OK/FAIL, are located directly on the faceplate of the RCB.
functions of the Routing Engine interface of the RCB. There are three LEDs on the craft interface for each
Routing Engine (RE0 and RE1). These LEDs are labeled MASTER, ONLINE, and OFFLINE.
NOTE:
The GPS LED is lit when the RCB is connected to an external clocking interface.
The Control Board, part of the host subsystem, has a set of bicolor LEDs that display its status. The LEDs,
labeled LINK, GPS, and BITS, are located directly on the faceplate of the RCB.
the functions of the Control Board interface of the RCB. There are two LEDs on the craft interface for
each Control Board—one labeled CB-RE0 (far left) and one labeled CB-RE1 (far right). For more information
about the RCB and Routing Engine LEDs on the craft interface, see
Craft Interface" on page
47.
Table 46 on page 129
describes the
Table 46 on page 129
"MX2008 Component LEDs on the
128
describes
Advertisement
Table of Contents
