Table of Contents
Advertisement
Replacing the MX2008 Extended Cable Manager
IN THIS SECTION
Removing the MX2008 Extended Cable Manager | 354
Removing the MX2008 Extended DC Cable Manager | 355
Installing the MX2008 Extended Cable Manager | 356
Installing the MX2008 Extended DC Cable Manager | 357
Removing the MX2008 Extended Cable Manager
To remove the extended cable manager:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. To remove the cover, loosen the two captive screws on the extended cable manager cover. Set the
extended cable manager cover aside.
3. Remove the eight screws that secure the extended cable manager to the chassis as shown in
Figure 144 on page
355.
4. Pull the extended cable manager away from the chassis.
354
Advertisement
Table of Contents
