Juniper MX2008 Hardware Manual page 265

12. With four people pushing on the front-mounting flanges, slide the router until the center-mounting
brackets (open-frame racks) or front-mounting flanges (four-post racks) contact the rack rails. In a
four-post rack, the mounting shelf ensures that the holes in the front-mounting flanges of the chassis
align with the holes in the rack rails.
13. Move the pallet jack away from the rack.
14. Insert twelve mounting screws (six on each side) into the mounting holes to secure the router to the
rack.
15. Visually inspect the alignment of the router. If the router is installed properly in the rack, all the mounting
screws on one side of the rack should be aligned with the mounting screws on the opposite side, and
the router should be level.
SEE ALSO
Installing an MX2008 Router Overview | 229
Installing an MX2008 Router Using a Router Transport Kit Overview
1. Gather the tools required to install the router. See:
Tools Required to Install the MX2008 Router Using a Router Transport Kit on page 266
2. Install the router transport kit. See:
Installing the Router Transport Kit on the MX2008 on page 267
3. Secure the router to the router transport platform. See:
Securing the MX2008 Router to the Router Transport Platform on page 269
4. Install the router using the router transport kit. See either:
"Using the Router Transport Kit to Install the MX2008 Router in a Four-Post Rack" on page 272
the Router Transport Kit to Install the MX2008 Router in an Open-Frame Rack on page 279
SEE ALSO
265
or Using