Juniper MX2008 Hardware Manual page 317

9. Verify that the LEDs on the PDM faceplate are lit steadily green, indicating that the AC terminal block
is receiving power.
10. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
WARNING:
dangerous voltages.
SEE ALSO
MX2008 AC Power Cord Specifications | 82
MX2008 AC Power System Electrical Specifications | 85
Connect Power to a Single-Phase Seven-Feed AC Power Distribution
Module
CAUTION:
same router.
To connect an AC power cord to an AC power source:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
2. Switch off the dedicated customer site circuit breakers. Ensure that the voltage across the AC power
source cable leads is 0 V and that there is no chance that the cable leads might become active during
installation.
3. Detach the ESD grounding strap from the approved site ESD grounding point, and connect the strap
to one of the ESD points on the chassis.
4. Switch off (O) the AC power supply modules (PSMs) and disengage all AC PSMs.
Do not touch the power connectors on the PDM. They can contain
Do not mix AC and DC power distribution modules (PDMs) within the
317