Table of Contents
Advertisement
SEE ALSO
Replacing an MX2008 SFB | 406
MX2008 Interface Modules
IN THIS SECTION
MX2000 Adapter Card (ADC) Description | 162
MX2008 Modular Port Concentrator Description | 163
MX2008 Modular Port Concentrator LEDs | 166
MPCs Supported by MX Series Routers | 166
MX2008 MPC Terminology | 171
MX2008 Modular Interface Card Description | 172
MICs Supported by MX Series Routers | 173
MX2008 Modular Interface Card LEDs | 183
MX2008 Ports and Interfaces | 184
MX2000 Adapter Card (ADC) Description
The MX2000 routers are compatible with all Trio-based MPC line cards; However, because the MX2000
routers use a newer-generation Switch Fabric Board (SFB) with faster bandwidth, smaller form-factor
MPCs must use a special Line Card Adapter (ADC). The ADC is merely a shell that accepts line cards in
the front and converts power and switch fabric in the rear. ADCs install vertically in the front of the router.
The following MPCs require an ADC:
MPC1E
MPC2E
MPC3E
MPC5E
MPC7E
162
Advertisement
Table of Contents
