Table of Contents
Advertisement
When the router boots, it first attempts to start the image on the USB flash drive. If a USB flash drive is
not inserted into the RCB or the attempt otherwise fails, then the router next tries the SSD.
You configure the router by issuing Junos OS CLI commands, either on a console device attached to the
CONSOLE port on the Routing Engine or over a Telnet connection to a network connected to the MGMT
port on the Routing Engine.
Figure 143: USB Flash Drive Port on RCB
Gather the following information before configuring the router:
Name the router will use on the network
Domain name the router will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
This procedure connects the router to the network but does not enable it to forward traffic. For complete
information about enabling the router to forward traffic, including examples, see the Junos OS configuration
guides.
To configure the software:
1. Verify that the router is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
344
Advertisement
Table of Contents
