Table of Contents
Advertisement
Figure 152: Removing the EMI Card-Cage Cover
4
Installing the MX2008 Standard EMI Cover
The MPCs require an EMI cover to reduce the risk of radio frequency interference disturbance that affects
an electrical circuit because of electromagnetic interference emitted from an external source. The EMI
cover is designed to reduce the electromagnetic interference (EMI) to comply with the Federal
Communications Commission (FCC) requirements.
To install the EMI card-cage cover (see
1. Align the four brackets on either side of the EMI cover with the chassis front-mounting flanges on the
outside of the card cage.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Adjust the EMI cover until the four captive screws align with the holes in the front-mounting flanges.
3. Tighten the four captive screws to secure the EMI cover in place.
Figure 153 on page
365):
364
Advertisement
Table of Contents
