Table of Contents
Advertisement
4. Verify that the INP0 and/or INP1 LEDs on the PSM are lit green steadily (see
.
NOTE:
If you are connecting two feeds, INP0 and INP1, both LEDs on the PSM are lit green
steadily.
5. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
6. Move the switch to the on (|) position.
7. Verify that the PWR OK LED is lit green steadily. See
page 104
for information about MX2008 DC PSM LEDs.
8. Repeat Steps
1
through
Figure 130: MX2008 DC Power Supply Module Front View
NOTE:
Each PSM slot not occupied by a DC PSM must be covered by a PSM blank panel.
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX2008 Router | 544
Powering On the DC-Powered (-48 V) MX2008 Router | 335
7
for installing PSMs in slots 0, 1, and 2, where required.
Figure 130 on page
"MX2008 DC Power Supply Module LEDs" on
322
322)
Advertisement
Table of Contents
