Table of Contents
Advertisement
SEE ALSO
Removing the Fan Trays Before Installing an MX2010 Router with a Pallet Jack | 252
Reinstalling the SFBs After Installing the MX2010 Router with a Pallet Jack
To reinstall an SFB (see
CAUTION:
stored horizontally and pressed toward the center of the SFB.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each SFB to be installed out of its electrostatic bag, and identify the slot on the SFB where it will
be connected.
3. Carefully align the sides of the SFB with the guides inside the chassis.
4. Slide the SFB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
5. Grasp both ejector handles, and gently close them inward simultaneously until the SFB is fully seated.
6. Place the ejector handles in their proper position, vertically and toward the center of the board.
CAUTION:
replacement or blank panel to install.
Figure 116 on page
293):
Before removing or replacing an SFB, ensure that the ejector handles are
If one of the SFBs fails, do not remove the failed SFB until you have a
292
Advertisement
Table of Contents
