Table of Contents
Advertisement
Removing the MX2008 RCB
To remove an RCB (see
NOTE:
Remove the RCB as a unit.
CAUTION:
handles properly to avoid damage to the equipment.
CAUTION:
there is only one host subsystem, taking the host subsystem offline shuts down the
router.
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
3. Open the ejector handle outward to unseat the RCB.
4. Grasp the ejector handle, and slide the RCB about halfway out of the chassis.
5. Place one hand underneath the RCB to support it, and slide it completely out of the chassis.
6. Place the RCB on the antistatic mat or inside an antistatic bag.
7. If you are not replacing the RCB immediately, install a blank panel over the empty slot.
Figure 179 on page
420):
Before removing a RCB, ensure that you know how to operate the ejector
Before you replace a RCB, you must take the host subsystem offline. If
419
Advertisement
Table of Contents
