Table of Contents
Advertisement
Figure 164: Removing a Single-Wide MIC
Installing an MX2008 MIC
To install a MIC (see
Figure 166 on page
NOTE:
Steps involved to remove or install a MIC are the same for MX2008, MX2010, and
MX2020 routers.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. If you have used a dual-wide MIC and are now replacing it with two single-wide MICs, install the septum
(see
Figure 165 on page 382
a. Place the MPC on a flat surface (if necessary, remove the MPC from the adapter card as described
in
"Replacing an MX2008 MPC" on page
b. Position the septum in the center of the MPC so that it lines up with holes labeled S on the top of
the MPC.
c. Insert a screw into each of the two holes labeled S, and then tighten them completely.
384):
):
389.
381
Advertisement
Table of Contents
