Juniper MX2008 Hardware Manual page 310

NOTE: We recommend that you use the proper gauge wire in order for the cable clamps to
hold the AC cables. Using smaller gauge wiring results in the cable clamps not tightening
properly.
WARNING:
13. Verify that the power cable connections are correct.
14. Screw the retaining nut onto the AC power cord to secure it to the metal wiring compartment.
15. Reinstall the metal PDM wiring cover, and using a number 2 Phillips (+) screwdriver, tighten the four
captive screws on the metal AC wiring compartment.
16. Use the provided plastic cable tie to fasten the AC power cord to the PDM.
17. Verify that the AC power cord does not touch or block access to router components, and that it does
not drape where people could trip on it.
18. Repeat the procedure for the other three-phase delta AC PDMs.
SEE ALSO
MX2008 Three-Phase Delta AC Power Distribution Module Electrical Specifications | 89
MX2008 Three-Phase Delta and Wye AC Power Distribution Module LEDs | 73
Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2008
Router | 91
MX2008 AC Power System Electrical Specifications | 85
MX2008 AC Power Cord Specifications | 82
Preventing Electrostatic Discharge Damage to an MX2008 Router | 544
Power connections must be performed by a licensed electrician only.
310