Juniper MX2008 Hardware Manual page 494

Table 116: MX2008 Cooling System Alarms (continued)
Component
Temperature sensors
SEE ALSO
MX2008 Craft Interface Description | 43
Replacing the MX2008 Air Filters | 369
Replacing an MX2008 Fan Tray | 374
Alarm
Type CLI Message
Red Temperature Hot
Temperature sensor
failure
Yellow Temperature Warm
Alarm Condition Solution
The chassis Verify that the
temperature room temperature
exceeded the hot is within
temperature acceptable limits.
threshold. If this
Verify that there
condition persists, the
is sufficient air
router shuts down.
flow.
Verify that the
cooling system in
the chassis is
operating
properly.
A temperature sensor Contact JTAC
failed.
The chassis Verify that the
temperature room temperature
exceeded the warm is within
temperature acceptable limits.
threshold.
Verify that there
is sufficient air
flow.
Verify that the
cooling system in
the chassis is
operating
properly.
494