Table of Contents
Advertisement
Figure 116: Reinstalling an SFB
SEE ALSO
Removing the SFBs Before Installing an MX2010 Router with a Pallet Jack | 254
Reinstalling the Adapter Card After Installing the MX2010 Router with a Pallet Jack
To reinstall an ADC (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each ADC to be installed out of its electrostatic bag, and identify the slot where it will be installed.
3. Locate the slot in the card cage in which you plan to install the ADC.
4. Ensure that the ADC is right-side up, with the text on the faceplate facing upward.
5. Lift the ADC into place, and carefully align first the bottom, then the top of the ADC with the guides
inside the card cage.
6. Slide the ADC all the way into the card cage until you feel resistance.
7. Grasp both ejector handles, and gently close them inward simultaneously until the ADC is fully seated.
Figure 117 on page
294):
293
Advertisement
Table of Contents
