Table of Contents
Advertisement
If any of the status LEDs indicates that the PDM is not functioning normally, repeat the installation and
cabling procedures.
8. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
9. Move the power switch on one of the PSMs to the on (|) position. The OK LED blinks momentarily,
then lights steadily.
NOTE:
After a PSM and a PDM are powered on, it can take up to 60 seconds for status
indicators—such as the output status LEDs on the PSM, and the command output on the
craft interface—to indicate that the PSM and PDM are functioning normally. Ignore error
indicators that appear during the first 60 seconds.
10. Verify that the PWR OK LED on the AC PSM faceplate is lit steadily, indicating that PDM is correctly
installed, functioning properly, and providing power to the AC outputs.
11. On the external management device connected to the Routing Engine, monitor the startup process to
verify that the system has booted properly.
12. Verify that the router powers up and goes through the system initialization process.
SEE ALSO
Initially Configuring the MX2010 Router
Maintaining and Verifying the Status of the MX2010 Router Components
Initially Configuring the MX2020 Router
Maintaining and Verifying the Status of the MX2020 Router Components
MX2000 Three-Phase Delta AC Power Distribution Module Description
MX2000 Three-Phase Wye AC Power Distribution Module Description
Connecting the MX2000 Series Router to a Console or Auxiliary Device
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution Modules
Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2000 Routers
Preventing Electrostatic Discharge Damage to an MX2010 Router
Preventing Electrostatic Discharge Damage to an MX2020 Router
319
Advertisement
Table of Contents
