Juniper MX2008 Hardware Manual page 403

WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
4. Remove the cable from the cable manager, and detach it from the destination port.
Installing a Cable on an MX2008 MPC or MIC
To install a MIC cable or an MPC cable (see
1. Have ready a length of the type of cable used by the component. For cable specifications, see the
Series Interface Module
2. If the cable connector port is covered by a rubber safety cap, remove the cap.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected to a
transceiver emit laser light that can damage your eyes.
CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
3. Insert the cable connector into the cable connector port on the component faceplate.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when inserting
Figure 173 on page
Reference.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when inserting
404):
403
MX