Table of Contents
Advertisement
12. Remove the winch mount and winch strap plate, and set them aside.
13. Insert twelve mounting screws (six on each side) into the mounting holes to secure the router to the
rack.
14. Visually inspect the alignment of the router. To verify that the router is installed properly in the rack,
see that all the mounting screws on one side of the rack are aligned with the mounting screws on the
opposite side and the router is level.
15. Reassemble the router transport kit, and set it aside.
SEE ALSO
Preparing the Site for the MX2008 Router Overview
Tools Required to Install the MX2008 Router Using a Router Transport Kit | 266
MX2008 Router Transport Kit Moving Requirements and Guidelines | 189
Removing Components from the MX2008 Router Chassis Before Installing It in a Rack | 245
Reinstalling Components in the MX2008 Router After Initially Installing the Router in a Rack | 284
Using the Router Transport Kit to Install the MX2008 Router in an
Open-Frame Rack
NOTE:
Four persons are needed to install the router into a rack.
CAUTION:
verify that the rack is strong enough to support the router's weight and is adequately
supported at the installation site.
Before front-mounting the router in a rack, have a qualified technician
279
Advertisement
Table of Contents
