Table of Contents
Advertisement
d. Insert the wire labeled L3 into the input terminal labeled C1.
e. Insert the wire labeled N into the input terminal labeled N1.
Figure 121: Connecting Power to a Three-Phase Wye AC Power Distribution Module
NOTE:
The three-phase wye AC PDM terminal blocks will be flipped depending on which
slot the PDM gets plugged into.
NOTE:
The color of each AC power wire might vary. The MX2008 chassis is not sensitive to
phase rotation sequence—either CW or CCW will operate correctly.
CAUTION:
If using your own cable, make sure you use the proper connections.
Wire label configuration is for Juniper Networks supplied cable only.
301
Advertisement
Table of Contents
