Table of Contents
Advertisement
9/16-in. or 14-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
ESD wrist strap
Antistatic mat
SEE ALSO
MX2008 Chassis Description | 27
MX2008 Field-Replaceable Units | 38
Unpacking the MX2008 Router Overview | 231
Installing the Pallet Jack Attachment
To install the pallet jack attachment to the pallet jack:
1. Remove the pallet jack attachment from the shipping crate.
2. Place the pallet jack attachment across both pallet jack legs.
3. Using a 9/16-in. (14 mm) socket wrench, loosen and remove the eight shipping bracket support torque
fasteners that are located on the top of the pallet jack attachment platform.
4. Using a 9/16-in. (14 mm) socket wrench, loosen the torque fasteners that are located on the four
adjustable pallet jack attachment brackets.
5. Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
6. Tighten the torque fasteners by using a 9/16-in. (14 mm) socket wrench to secure the brackets on the
pallet jack attachment to the pallet jack (see
Figure 91 on page
261).
260
Advertisement
Table of Contents
