Table of Contents
Advertisement
3. Open both ejector handles simultaneously to unseat the CB-RE.
4. Grasp the handles, and slide the CB-RE straight out of the card cage halfway.
5. Place one hand around the front of the CB-RE and the other hand under it to support it. Slide the CB-RE
completely out of the chassis, and place it on the antistatic mat or in the electrostatic bag.
CAUTION:
to accept the full weight—up to 15 lb (6.8 kg)—as you slide the CB-RE out of the
chassis.
When the CB-RE is out of the chassis, do not hold it by the ejector handles, bus
bars, or edge connectors. They cannot support its weight.
CAUTION:
each component on an antistatic mat resting on a stable, flat surface.
Figure 90: Removing a CB-RE
SEE ALSO
The weight of the CB-RE is concentrated in the back end. Be prepared
Do not stack CB-REs on one another after you remove them. Place
258
Advertisement
Table of Contents
