Table of Contents
Advertisement
Removing the SFBs Before Installing an MX2010 Router with a Pallet Jack
To remove the SFBs (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
3. Open the ejector handles outward simultaneously to unseat the SFB.
4. Grasp the ejector handles, and slide the SFB about halfway out of the chassis.
5. Place one hand underneath the SFB to support it, and slide it completely out of the chassis. Place it on
the antistatic mat.
CAUTION:
accept the full weight—up to 12 lb (5.45 kg)—as you slide the SFB out of the chassis.
CAUTION:
them. Place each component on an antistatic mat resting on a stable, flat surface.
6. Repeat the procedure for each SFB.
Figure 88 on page
255):
The weight of the SFB is concentrated in the back end. Be prepared to
Do not stack hardware components on one another after you remove
254
Advertisement
Table of Contents
