Juniper MX2008 Hardware Manual page 350

Maintaining MX2008 Components
IN THIS SECTION
Tools and Parts Required for Replacing MX2008 Hardware Components | 350
Tools and Parts Required to Remove Components from an MX2008 Router | 353
Tools and Parts Required to Maintain the MX2008 Hardware Components | 353
Replacing the MX2008 Extended Cable Manager | 354
Replacing the MX2008 Craft Interface | 358
Replacing the MX2008 Standard EMI Cover | 363
Replacing the MX2008 Extended EMI Cover | 365
Tools and Parts Required for Replacing MX2008 Hardware Components
To replace hardware components, you need the tools and parts listed in
Table 109: Tools and Parts Required for Component Replacement
Components
All
AC power supply module
AC power distribution module
Three-phase delta AC PDM
Three-phase wye AC PDM
Tool or Part
Electrostatic discharge (ESD) grounding wrist strap
Phillips (+) screwdrivers, number 1 and 2
Phillips (+) screwdriver, number 2 to access the metal
AC wiring compartment
7/16-in. (11 mm) hexagonal-head external drive socket
wrench, or nut driver, with a torque range between
23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm) to attach the
ground wire.
1/4-in. slotted screwdriver and 5/32-in. (4 mm) Allen
wrench to attach input terminal wires of the AC power
cord.
Table 109 on page 350.
350