Table of Contents
Advertisement
Figure 166: Installing a MIC
4
Installing an MX2008 Dual-Wide MIC
To install a dual-wide MIC:
NOTE:
Steps involved to remove or install a MIC are the same for MX2008, MX2010, and
MX2020 routers.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the septum, if necessary (see
a. Place the MPC on a flat surface. If necessary, remove the MPC from the adapter card as described
in
"Replacing an MX2008 MPC" on page
b. Remove the four screws labeled S on the bottom of the MPC.
c. Remove the two screws labeled S on the top of the MPC.
d. Slide the septum toward you and out of the MPC.
Figure 167 on page
385):
389.
384
Advertisement
Table of Contents
