5. Ensure that the CB-RE is right-side up, with the text on the faceplate of the CB-RE facing upward.
6. Lift the CB-RE into place, and carefully align first the bottom, then the top of the CB-RE with the guides
inside the card cage.
7. Slide the CB-RE all the way into the card cage until you feel resistance.
8. Grasp both ejector handles, and gently close them inward simultaneously until the CB-RE is fully seated.
Figure 119: Reinstalling a CB-RE
SEE ALSO
Removing the CB-REs Before Installing the MX2010 Router with a Pallet Jack | 257
SEE ALSO
Preparing the Site for the MX2008 Router Overview
Tools Required to Install the MX2008 Router Using a Pallet Jack | 259
Removing Components from the MX2008 Router Chassis Before Installing It in a Rack | 245
296