Juniper MX2008 Hardware Manual page 438

17. Using a number 2 Phillips (+) screwdriver, tighten the four captive screws on the metal AC wiring
compartment.
18. Verify that the AC power cord does not touch or block access to router components, and that it does
not drape where people could trip on it.
19. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
20. Connect the AC power cord plug to the power source.
21. Switch on the customer-site circuit breakers to provide voltage on the AC power cord.
22. Remove the ESD grounding strap from the approved site ESD grounding point. See the instructions
for your site. Reconnect the strap to one of the ESD points on the chassis.
23. Verify that the LED on the PDM faceplate is lit steadily, indicating that the AC terminal block is receiving
power.
SEE ALSO
MX2000 Three-Phase Delta AC Power Distribution Module Description
MX2000 Three-Phase Delta and Wye AC Power Distribution Module LEDs
Connecting AC Power to an MX2000 Router with Three-Phase Delta AC Power Distribution Modules
Powering On a Three-Phase AC-Powered MX2000 Router | 318
Powering Off the AC-Powered or Universal HVAC/HVDC-Powered MX2000 Router
Troubleshooting the MX2000 Router Power System | 495
MX2000 AC Power Cord Specifications
MX2000 AC Power System Electrical Specifications
MX2000 Three-Phase Delta AC Power Distribution Module Electrical Specifications
438