Table of Contents
Advertisement
Figure 110: Reinstalling a DC Power Distribution Module (240 V China)
SEE ALSO
Removing the Power Distribution Modules Before Installing an MX2010 Router with a Pallet Jack | 246
Reinstalling the Power Supply Modules After Installing the MX2010 Router with a Pallet Jack
To reinstall the AC or DC PSMs, follow this procedure for each PSM (see
Figure 112 on page
289) which shows the installation of the AC or DC PSM.
1. Remove the PSM to be installed out of the ESD bag, and identify the slot where it will be installed; 0
through 8 .
NOTE:
The MX2010 PSMs can be installed in any order in the chassis.
2. For an AC-powered router, move the AC power switch on the PSMs to the off (O) position. For a
DC-powered router, move the DC power switch on the PSMs to the off (O) position.
Figure 111 on page 289
288
and
Advertisement
Table of Contents
