Figure 144: Removing the Extended Cable Manager
Removing the MX2008 Extended DC Cable Manager
To remove the extended DC cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Using a Phillips (+) screwdriver (number 1 or 2), loosen the two captive screws on the DC cable manager.
3. Grasp the extended DC cable manager, lift up and pull straight out from the DC PDM on the rear of
the chassis.
4. Place the extended DC cable manager into an electrostatic bag and set it aside.
Figure 145 on page
356):
355