Table of Contents
Advertisement
SEE ALSO
MX2008 Power System Description | 58
Preventing Electrostatic Discharge Damage to an MX2008 Router | 544
MX2008 AC Power Requirements | 74
MX2008 AC Power Cord Specifications | 82
Replacing an MX2008 DC Power Supply Module (-48 V)
IN THIS SECTION
Removing an MX2008 DC Power Supply Module (-48 V) | 465
Installing an MX2008 DC Power Supply Module (-48 V) | 468
Removing an MX2008 DC Power Supply Module (-48 V)
Before you remove a PSM, be aware of the following:
CAUTION:
PSM, each PSM slot must contain either a PSM or a blank panel. If you remove a PSM,
you must install a replacement PSM or a blank panel shortly after the removal.
NOTE:
After powering off a PSM, wait at least 60 seconds before turning it back on.
To maintain proper cooling and prevent thermal shutdown of the operating
465
Advertisement
Table of Contents
