Table of Contents
Advertisement
CAUTION:
to accept the full weight—up to 18.35 lb (8.32 kg)—as you slide the MPC out of the
ADC.
When the MPC is out of the ADC, do not hold it by the knobs, bus bars, or edge
connectors. They cannot support its weight.
Do not stack MPCs on top of one another after removal. Place each one individually
in an electrostatic bag or on its own antistatic mat on a flat, stable surface.
Figure 89: Removing an MPC without the ADC
SEE ALSO
Reinstalling the MPCs After Installing the MX2010 Router with a Pallet Jack | 294
Removing the CB-REs Before Installing the MX2010 Router with a Pallet Jack
To remove a CB-RE (see
1. Have ready an antistatic mat for the CB-RE. Also have ready rubber safety caps for each SFP that uses
an optical interface on the CB-RE that you are removing.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
an approved site ESD grounding point. See the instructions for your site.
The weight of the MPC is concentrated in the back end. Be prepared
Figure 90 on page
258):
257
Advertisement
Table of Contents
