Table of Contents
Advertisement
Figure 179: Removing an RCB
Installing the MX2008 RCB
To install the RCB (see
Figure 180 on page
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the RCB from the electrostatic bag.
3. Carefully align the sides of the RCB with the guides inside the chassis.
4. Slide the RCB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
5. Grasp the ejector handle, and gently close it inward until the RCB is fully seated.
6. Check the LEDs on the RCB faceplate to verify that it is functioning normally.
The green ONLINE LED should blink green initially and light steadily a few minutes after the RCB is
installed.
If the OK/FAIL LED is yellow, remove and install the RCB again. If the OK/FAIL LED still lights
steadily, the RCB is not functioning properly. Contact your customer support representative. See
Contacting Customer Support.
7. Check the status of the RCB by using the show chassis environment cb command.
4
421):
420
Advertisement
Table of Contents
