Table of Contents
Advertisement
407
4. Grasp the ejector handle, and slide the SFB about halfway out of the chassis.
5. Place one hand underneath the SFB to support it, and slide it completely out of the chassis.
6. Place the SFB on the antistatic mat or into an antistatic bag.
7. If you are not replacing the SFB immediately, install a blank panel over the empty slot.
Figure 174: Removing an SFB
Installing an MX2008 SFB
To install an SFB (see
Figure 175 on page
408):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the SFB from the electrostatic bag.
3. Carefully align the sides of the SFB with the guides inside the chassis.
4. Slide the SFB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
5. Grasp the ejector handle, and gently close it inward until the SFB is fully seated.
6. Check the LEDs on the SFB faceplate to verify that it is functioning normally.
The green OK/FAIL LED should light steadily a few minutes after the SFB is installed.
Advertisement
Table of Contents
