Table of Contents
Advertisement
CAUTION:
or removing cable. The safety cap keeps the port clean and prevents accidental
exposure to laser light.
6. Arrange the cable to prevent it from dislodging or developing stress points. Secure the cable so that it
is not supporting its own weight as it hangs to the floor. Place excess cable out of the way in a neatly
coiled loop.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
7. On the MPC, pull the ejector lever that is adjacent to the MIC you are removing away from the MPC
faceplate. This disconnects the MIC from the MPC.
NOTE:
To remove a dual-wide MIC that takes up both MIC slots, you must pull both ejector
levers away from the MPC faceplate.
8. Grasp the handles on the MIC faceplate, and slide the MIC out of the MPC card carrier. Place it in the
electrostatic bag or on the antistatic mat.
9. If you are not reinstalling a MIC into the emptied MIC slot within a short time, install a blank MIC panel
over the slot to maintain proper airflow in the MPC card cage.
Do not leave a fiber-optic transceiver uncovered except when inserting
Avoid bending fiber-optic cable beyond its minimum bend radius. An
380
Advertisement
Table of Contents
