Table of Contents
Advertisement
Figure 123: MX2008 Router with AC Power Supply Modules Installed
4. Verify that the INP0 and/or INP1 LEDs on the PSM are lit green steadily (see
NOTE:
If you are connecting two feeds, INP0 and INP1, both LEDs on the PSM will be lit
green steadily.
5. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
6. Move the switch to the on (|) position.
7. Verify that the PWR OK LED is lit green steadily. See
page 65
for information about MX2008 AC PSM LEDs.
8. Repeat Steps
1
through
7
for installing PSMs in slots 0, 1, and 2, where required.
Figure 124 on page
"MX2008 AC Power Supply Module LEDs" on
305
306).
Advertisement
Table of Contents
