Preparation For Mobile Operation; Mobile Installation - Kenwood TM-733A Instruction Manual

PREPARATION FOR MOBILE OPERATION
When operating mobile, do not attempt to configure
your transceiver while driving because it is simply too
dangerous. Stop the car first, then make the necessary
changes. Also, be aware of local laws pertaining to the
use of headphones/headsets while driving on public
roads. If in doubt, do not wear headphones while
mobiling.
MOBILE INSTALLATION
Install the transceiver in a safe, convenient position
inside your vehicle that minimizes danger to your
passengers and yourself while the vehicle is in motion.
For example, consider installing the transceiver under
the dash in front of the passenger seat so that knees or
legs will not strike the radio during sudden braking of
your vehicle. Try to pick a well-ventilated location that
is shielded from direct sunlight. Leave sufficient space
behind the Rear Panel for the transceiver fan to
exhaust warm air.
gw Installation Example
1 Install the mounting bracket using the supplied
flat washers and self-tapping screws. There are
4 washers and 4 screws supplied.
The bracket can be mounted with the bracket
opening for the transceiver facing down for
underdash mounting, or with tne opening
facing up. Study the accompanying diagram
to determine the best installation method for
your situation.
Self-tapping screw
Se | yy | °O- SEMS screw