Open Auto Demand / Response Module; Isy Installation - Universal Devices ISY-994i User Manual

Now that your Climate Module has been configured, you can use this information as
Conditions in ISY Programs. When choosing a condition, choose Module and Climate to see
all available conditions:

6.6 Open Auto Demand / Response Module

*Requires firmware 4.1.3+

6.6.1 ISY Installation

• Connect one of the included Cat5e cable to ISY's Network Port and to your network
hub. Note: the network must initially be DHCP enabled.
• The following depends on the model:
o [ISY994 Series] If you have a Relay Board, connect the second included Cat5e
cable to ISY's Port A and the other end to the RJ45 connector on the Relay
Board. Power supply gets plugged into the barrel connector on the Relay
Board (not ISY)
o [ISY994i Series] If you have an INSTEON PLM, connect the second included
Cat53 cable to ISY's Port A and the other end to the PLM. Power supply gets
plugged into the Power jack on the back of ISY
Figure 74: Using Climate Conditions
Page | 76