Thermostat & Wireless Thermostat (2441Th / 2441Zth) - Universal Devices ISY-994i User Manual

• Put RemoteLinc2 in Programming Mode:
o Ensure the on/off switch is in the On position
o Press and hold the Set Button at the base of the RemoteLinc2 until the LED
starts flashing green (takes about 3 seconds)
• The Insteon address is on a sticker on the back of the RemoteLinc2.
After the nodes are added to the ISY press the set button on the RL2 twice to quit linking
mode.
• To maintain compatibility with the 4-Scene Keypad an 8-Scene Keypad uses groups
1, 3, 5, 7 for the buttons on the right side of the RemoteLinc2 (B, D, F, H) and groups
2, 4, 6, 8 for buttons on the left of the RemoteLinc2 (A, C, E, G).
13.20 Thermostat & Wireless Thermostat (2441TH / 2441ZTH)
There is a Program Action available to synchronize the Thermostat time with that of the
ISY.
13.20.1 Thermostat Adapter
Older INSTEON Thermostat Adapters cannot act as Controllers, thus they do not notify the
ISY of any state changes. To get the most current information from your thermostat, we
recommend using an ISY Program to poll the device periodically. See 11.9 Thermostat
Newer Thermostat Adapters (V2) do notify the ISY of state changes, so a poll Program will
not be necessary.
Figure 238: Link a RemoteLinc 2 Menu
Page | 387