Stop Adding Or Removing A Z-Wave Device - Universal Devices ISY-994i User Manual

15.1.12 Stop Adding or Removing a Z-Wave device

• Select
(11) Stop Adding or Removing a Z-Wave device to force the ISY to get out
of either include or exclude mode.
15.1.13 Factory Reset Z-Wave dongle
• Select
(12) Factory Reset Z-Wave Dongle
• All network information will be removed from the dongle, and it will be reset to
factory settings. In normal usage, factory reset should only be done if the dongle has
been removed from the Z-Wave network.
15.1.14 Select Z-Wave Antenna
• Select
(13) Select Z-Wave Antenna
o The green arrow indicates the antenna currently being used.
15.1.15 Upgrade Z-Wave firmware
• Select
(14) Upgrade Z-Wave firmware
o Upgrades the Z-Wave library on the dongle to the most currently supported
version.
15.1.16 Z-Wave Version
Select (15) Z-Wave Version
Library
Z-Wave Version
Bootloader Version
15.1.17 Importing an Existing Z-Wave Network
If you have the Primary Controller for your existing Z-Wave network, do the following to
import the network into ISY.
Figure 250: Select Z-Wave Antenna Menu
The Z-Wave library installed on
the Z-Wave dongle
The version of the Z-Wave library
installed on the Z-Wave dongle
The version of the bootloader on
the Z-Wave dongle
Page | 416