Device Toggles - Universal Devices ISY-994i User Manual

• click 'Back' to return to the list, and then back again.
• Create a 'Profile' by clicking +
• Select 'Event'
• In the filter, type 'device' and select 'Device Boot'
• There are no options to configure for this event, so hit 'Back'
• Select the 'Start Geofence' task you just created.
This will cause the geofence monitor to start when the Android device starts.
Now, create a 'State Variable' on the ISY called 'At_Work'. Set it's 'init' value to 2. Make a
note of its ID number. For purposes of example, I'm going to say mine is 28.
Create two tasks:
• ISY-Set-Work-Arrive
• ISY-Set-Work-Leave
Configure a geofence in AutoLocation
• Open 'AutoLocation' and click 'Manage Geofences'
• Click + to add a new Geofence
• In the map, select the center of the location you wish to fence.
• Adjust the size of the fenced area with the slider, and then click 'Accept Geofence'.
• Give it a name - 'Work'.
• Back on the list - Autolocation will tack on 'Inside' or 'Outside' as appropriate.
• Click 'Start Monitor' under the 'GEOFENCES' section.
Finally, create the Tasker profile that ties it all together:
• Create a new profile:
• 'State' 'Autolocation Geofences'
• For 'Configuration', select the 'Geofence Name' 'Work'.
• For 'Status' - select 'Inside'
• Click the 'Check' then hit 'Back'
• select 'ISY-Set-Work-Arrive' as the task to run on entering the geofence.
• In the profile list, long-press the 'ISY-Set-Work-Arrive' task, and select 'Add Exit
Task'
• select 'ISY-Set-Work-Leave' as the task to run when exiting the geofence.
19.1.6

Device Toggles

The steps outlined in 19.1.2 Network Awareness and 19.1.3 Base Task Dependencies
must be completed before this section. They not only setup prerequisites - but they also
serve as a tutorial on adding 'Tasks' and 'Profiles' to ISY.
Perform Task / ISY-SetVarState %par1=28 %par2=1
Perform Task / ISY-SetVarState %par1=28 %par2=0
Page | 519