Though this can be done with other automation controllers/software I'm sure, I'm doing it
on my ISY. Below are the 2 programs I'm using:
11.5.3.1Program: LAMP1
If
Status 'KeypadC' is On
And Status 'KeypadH' is On
And Status 'KeypadC' is not Off
And Status 'KeypadH' is not Off
Then
Set 'Lamp1' On
Else
Set 'Lamp1' Off
11.5.3.2Program: LAMP2
If
Status 'KeypadB' is On
And Status 'KeypadG' is On
And Status 'KeypadB' is not Off
And Status 'KeypadG' is not Off
Then
Set 'Lamp2' On
Else
Set 'Lamp2' Off
Page | 287