Z-Wave Notes - Universal Devices ISY-994i User Manual

15 Z-Wave Notes

15.1 Z-Wave Instructions
15.1.1 Requirements & Installation
ISY-994 Series with firmware version 4.1.1 or above (Help | About)
•
Z-Wave Module - 21100 (Help | About). If you do not have the Z-Wave Module,
•
please do make sure you have firmware 4.1.1 installed first and then use Admin
Console | Help | Purchase Modules ($1.00) to have it purchased/activated
Z-Wave Dongle, see
•
INSTEON PLM plugged into Port A
•
15.1.2 Add/Include a Z-Wave device
• Select
(1) Add/Include a Z-Wave Device
o If the popup window does not appear, select 15.1.12 Stop Adding or
Removing a Z-Wave device and the try again.
• Put the Z-Wave device in learn Mode. Refer to the user guide for your product on
how to do this. In many cases this just requires you to press a button on the device.
• The ISY will begin adding the device (this may occur a few seconds after you put the
device into learn mode).
o The popup window will go away and you will see your device added to the
tree.
Note: To add a device, it must not already be included in a Z-Wave network. Therefore,
if you are having trouble including a device try excluding it first.
Ordering/Assembly Instructions
Figure 243:
Z-Wave Menu
Page | 411