Linking A Triggerlinc – 2421 - Universal Devices ISY-994i User Manual

Since the TriggerLinc is a battery-saving RF device, you must put the device into linking
mode to add it to the ISY (and make any changes to the device, such as adding/removing
from scenes). Please follow the on-screen instructions to put the TriggerLinc into linking
mode when prompted (hold SET button for 5 seconds).
Once added to the ISY, the TriggerLinc will show up as 2 nodes. The secondary node is only
used when the TriggerLinc is in "Multi-Scene" mode.
When in Normal mode, the TriggerLinc sends an ON command to the primary node when
the sensor is open (magnet pulled away) and an OFF command when the sensor is closed
(magnet close to sensor).
When in Multi-Scene mode, the TriggerLinc sends an ON command to the first node when
the sensor is open, and an ON command to the second node when the sensor is closed. It
will NOT send an OFF command to either node when in Multi-Scene mode.
13.21.1 Linking a TriggerLinc – 2421
• The Insteon TriggerLinc cannot be linked using Auto Discover.
• Menu - Link Management/New INSTEON device
• Enter the address.
o The TriggerLinc address is on a sticker inside the battery compartment.
• Select the TriggerLinc [10.02] from the drop down list.
• Click Ok.
• Press and Hold the Set button for 5 seconds to put the TriggerLinc in linking mode
as per the requester.
70 (Universal Devices)
70
Page | 390