Update The Isy With Network Changes - Universal Devices ISY-994i User Manual

15.1.20 Update the ISY with Network changes

From the Admin Console, Select Z-Wave -> Replicate (Learn Mode) and wait for a
•
popup window to appear
Use the instructions for your Primary Controller to include a device into the
•
network
Wait until the transfer is complete; the instructions for your Primary Controller
•
should tell you what to look for (e.g. LEDs stop flashing, it beeps, etc.)
You should start seeing the Z-Wave devices appear in the ISY device tree
•
15.1.21 Remove Devices
Select Remove/Exclude a Z-Wave Device from the menu and wait for a popup
•
window to appear.
If the popup window does not appear, Select Stop Adding or Removing a Z-
o
Wave Device from the advanced menu then try again.
Put the Z-Wave device in link mode. Refer to the user guide for your product on how
•
to do this. In many cases, this just requires you to press a button on the device.
The ISY will remove the device (this may occur a few seconds after you put the
•
device in link mode)
The popup window will go away, but you will NOT see your device removed
o
from the tree.
Notes
Deleting a node from the ISY does not delete it from the Z-Wave dongle.
•
When nodes are removed with a different controller, the ISY nodes are disabled
•
instead of deleted. This is done in case the user accidentally removes ISY from the Z-
Wave network, which essentially tells ISY that all nodes are deleted. We may change
this behavior based on Alpha feedback.
Page | 418