Procedure For Adding A New Leak Sensor - Universal Devices ISY-994i User Manual

11.6.1.5Procedure for Adding a New Leak Sensor

• Add device
• Add state variable (sLeakSensorName)
• Add programs: Variable Control 1, Variable Control 2, Variable Control 3
• Modify Leak Startup program
• Modify Leak Sensor Activation program and Leak Sensor Activation notification
• Modify Leak Sensor Problem program and Leak Sensor Problem notification
• Test leak sensor in "wet" mode and ensure notification is sent
11.7 Light Control Programs
11.7.1 Light Data Program
11.7.1.1Folder: Everyday
Folder Conditions for 'Everyday'' Add conditions to limit when programs in this folder are
allowed to run.
If
From Sunrise
To
Then
Allow the programs in this folder to run.
If it becomes dark during the day this program will turn the lights on.
40 (Universal Devices)
40
Sunset (same day)
Page | 297