9.2.4.3Action
The "Action" button adds the action information in the 'Then' and 'Else' section of the
program. It is defining the action taken after the condition is met or the trigger occurs.
An Action can be setting a device to a defined state that is ON/OFF or set level. The type of
Action is dependent on the device type. The two types of device Actions that are supported
are INSTEON or Send X10.
Insteon
• Set an Insteon device or scene (eg. set the On-Level of a lamp)
• Optionally (with the add-on A10/X10 module) A10/X10 devices that have been
added to the Device tree can be controlled.
Send X10
Sends this as a complete X10 command.
• This X10 command will be sent as a pair of messages, the first identifying the X10
devices, the second containing the command.
Figure 136: Action drop-down
Figure 137: Adding an X10 action to a program
Page | 150