Setup – First Leak Sensor - Universal Devices ISY-994i User Manual

11.6.1.2Setup – First Leak Sensor
Add the leak sensor device to the ISY, for this example we'll call it Kitchen Sink
Create a state variable called sLeakKitchenSink; set Init = 1 and Value = 1
Create a program called KitchenSink - Variable Control 1:
If
Status 'Leak Sensors / Kitchen Sink-Wet' is On
Then
$sLeakKitchenSink = 9
Else
Wait 10 seconds
$sLeakKitchenSink = 1
Create a program called KitchenSink - Variable Control 2:
If
Control 'Leak Sensors / Kitchen Sink-Heartbeat' is switched On
Or Control 'Leak Sensors / Kitchen Sink-Heartbeat' is switched Off
Then
$sLeakKitchenSink = 1
Wait 25 hours
$sLeakKitchenSink = 2
Else
- No Actions - (To add one, press 'Action')
Page | 292