Link A Sensor - Universal Devices ISY-994i User Manual

• Put RemoteLinc2 in Programming Mode:
o Ensure the on/off switch is in the On position
o Press and hold the Set Button at the base of the RemoteLinc2 until the LED
starts flashing green (takes about 3 seconds)
• The Insteon address is on a sticker on the back of the RemoteLinc2.
After the nodes are added to the ISY press the set button on the RL2 twice to quit linking
mode.
• To maintain compatibility with the 4-Scene Keypad an 8-Scene Keypad uses groups
1, 3, 5, 7 for the buttons on the right side of the RemoteLinc2 (B, D, F, H) and groups
2, 4, 6, 8 for buttons on the left of the RemoteLinc2 (A, C, E, G).

5.2.2.5Link a Sensor

5.2.2.5.1Link an Open/Close Sensor
Figure 26: All Link Sensors have this type of popup
Figure 27: Link an Open/Close Sensor
Page | 34