Program Resume Kitchen Island (K6) Off - Universal Devices ISY-994i User Manual

14.1.8

Program Resume Kitchen Island (K6) Off

If
- No Conditions - (To add one, press 'Schedule' or 'Condition')
Then
Send X10 'K6/Off (11)'
Else
- No Actions - (To add one, press 'Action')
The transmitted X-10 On or Off command will cause the Status program to resume its
correct state.
Finally, to have some devices always go to a predetermined state at startup, rather than
resuming a pre-fail state, a single program set to run at startup can be used to send a list of
X-10 commands to set the requisite devices on or off.
14.2 Using X-10 Motion Sensors
Small, inexpensive motion sensors have long been a popular part of the X-10 world. You
can put them to good use in conjunction with ISY for control of INSTEON lighting. This
article discusses the use of X-10 motion sensors with ISY and provides examples of ISY
programming for X-10.
72 (Universal Devices)
72
Page | 397