Change The Sd Card (Skip This Step If You're Only Formatting The Sd Card) - Universal Devices ISY-994i User Manual

23.15.1 Change the SD Card (skip this step if you're only formatting the SD
card)
• Remove the screws that attach the lid to the ISY.
• Remove the four screws that secure the circuit board inside the case (ISY-99i only)
o Please note: newer ISYs now have access to the SD Card from the outside of
the unit so no disassembly is required
• Remove the old SD Card and replace with the new card
• Please note: ISY supports up to a 16GB SD card with 4.2.18 firmware and above, any
firmware before this only supports a 512MB SD card
• Reassemble the ISY in the reverse order
23.15.2 Format the SD Card - you do NOT have to format the SD Card if it's new
• Telnet To Your ISY, see section 21.1 Telnet to Your ISY
• Login with the admin password
• Issue "FS" to format the SD Card, answer the "Are you sure question" with an upper
case "Y"
Figure 418: Inside View of ISY
Page | 634