New Insteon/A10/X10 Device; New Scene - Universal Devices ISY-994i User Manual

5.2.2.11New INSTEON/A10/X10 Device

NOTE: This option is entitled New INSTEON/X10/A10 Device if the optional X10 Module
is installed. Please see 6.4 A10/X10 Experimental Support for more information.
Choose this menu if you already know the INSTEON address of a device and if you do not
wish to use the regular linking method of pressing the "Set" button.
After selecting this menu option, the "New Insteon Device" dialog appears as shown below:
• Enter the INSTEON address of the device using the following format where A, B, and
C are the address parts as depicted on the INSTEON device itself
o A B C or
o A.B.C
• Optionally you can select the Device Type from the drop-down list
• Click on "Ok"
This operation performs the same action as the New INSTEON Device button on the tool
bar ( ).

5.2.2.12New Scene

Creating Scenes in ISY allows the user to set ramp rates, set on level, link or group devices
without physically going to each device(s) to manually set, link or group them. Let's say you
want to link a device in a bedroom to a device in the kitchen. When manually linking these
devices, you will have to physically go to the bedroom device set it to linking mode then go
to the kitchen device set it to linking mode. This process can be done via the ISY by creating
a scene, naming it, then placing the bedroom and kitchen devices into the scene. The
system will automatically link and program the devices.
Once you select this menu you will be presented with the "New Scene" dialog requesting a
name for the new Scene. Enter the name you prefer (the name can be changed at a later
time) and click on "Ok". The new scene will be added to the tree view on the left pane.
Figure 35: New INSTEON/A10/X10 Screen
Page | 39